OBD2 tools on OBD2shop.co.uk https://blog.dnevnik.hr/obd2shop

četvrtak, 03.04.2025.

Writing VIN on Buick Delphi MT60 ECM Using OBDSTAR DC706

To write the VIN on a Buick Delphi MT60 ECM using the OBDSTAR DC706 ECU tool, follow these structured steps:

Required Tools:

OBDSTAR DC706 (or X300 Classic G3)
High-power DC regulated power supply
Main cable
ECU clone jumper
MP001 programmer
Delphi MT60 ECM


Preparation:
Ensure the software is updated to the latest version before starting.

Steps to Write VIN:
1. Access ECU Flasher
Tap [ECU Flasher] > [ECM] > [ECM V31.70].
Use the search function in the upper-right corner to locate the module quickly.

2. Review Guide & Connection Methods
Tap [Guide] and carefully read the operation instructions.
Review the procedures for both the BOOT and BENCH modes.


3. Select and Verify Connection Mode
Open [Pinout], select [BENCH], and confirm the module's appearance matches your ECU.
Open [Connector Pinout] and follow the connection diagram.




4. Establish Connection
Connect the module accordingly.
Tap [Start] to begin.
Note: If cloning the ECU, use the BOOT mode instead.

5. Backup Original Data
After a successful connection, back up the original ECU data.
Customize the file name as needed.


6. Write the VIN
Tap [Write VIN].
Enter the new VIN.
Confirm the update. Writing completed!



Conclusion:
By following these steps, you can efficiently modify the VIN on the Delphi MT60 ECM using OBDSTAR DC706. Always ensure data backup before making changes.

Video guides:
https://youtu.be/NHIIupUw5GI

www.obd2shop.co.uk

Oznake: obdstar dc706

03.04.2025. u 04:14 • 0 Komentara • Print • # • ^

<< Arhiva >>

Creative Commons License
Ovaj blog je ustupljen pod Creative Commons licencom Imenovanje-Dijeli pod istim uvjetima.