This post will guide you on cutting a dimple key using the Xhorse Condor XC 002 PRO Mechanical Key Cutting Machine.

Click on the video to view the full operation:
https://youtu.be/8zRszvxmw5A

Here are the steps:

1. Insert the dimple probe and cutter (internal).
2. Insert the original key and the blank key using a shim.
3. Rotate the knob to standard mode.




4. Press down the handle and finish the calibration.
Just follow the direction of the light and rotate the micro-adjust knob until the middle light turns green.
Make sure that the clamp is in the corresponding position.



5. Duplicate the key.
Turn on the cutter switch and press down the main handle to duplicate the key.
Turn off the switch after finishing one side cutting.
Flip the key and continue to cut the other side.
After finishing one side, turn off the switch and clean up.



6. Insert the dimple probe and cutter (external).
Replace the internal dimple probe and cutter with external ones.


7. Switch the knob to dimple mode.


8. Insert the keys
9. Finish the calibration.
Clamp the keys and don't forget to complete the calibration.


10. Duplicate the key.
Turn on the switch to cut the key.
After finishing one side, turn off the switch and clean up.
Flip the key and cut the other side.
Done!



It works perfectly.

www.xhorse.co.uk

Oznake: condor xc002 pro