Problem: The date on the Xhorse Condor XC-Mini Plus key cutting machine will recover automatically after the restart, even if I had set the date before.

What should I do? Please help.

Solution
The reason for this problem is because of the dead battery on the mainboard. Only to remove the shell of the machine and replace a new CR1220 battery into the mainboard. The problem will not recur.

Thanks to www.xhorse.co.uk, the problem was solved.

Technical Support
Email: sales01@xhorse.co.uk
Skype: service@xhorse.co.uk
Whatsapp: +86-15696171957

Oznake: xhorse condor xc mini plus

This post will guide you on how to use Xhorse Condor XC-Mini Plus key cutting machine to cut a HU162T-9/10 key.

1. Enter “Cut by Bitting”, select HU162T-9 (this article takes HU162T-9 as an example), then click on "Confirm".


2. Select "Learn" or insert the 9 cuts on the front, select side B of the clamp, learn, enter and cut.



3. After cutting the front face, go back to the previous page and choose to learn or insert the 3 cuts on the side of the key, and select side D for the clamp.




Note: A HU162T key blank is needed to assist the clamp can be tightly clamped.


Technical support
www.xhorse.co.uk

Oznake: xhorse condor xc mini plus