Marketing
Launch X431 X-Prog3 IMMO Wire Connection Instruction
Launch X-Prog 3 Immobilizer Programmer is used to read & write car key chip data, compatible with a variety of X431 diagnostic tools like X431 V+, X431 PRO5, X431 PRO3S+, etc.
This is a quick guide on how to connect GIII X-Prog3 with the X431 scan tool.
Connection Instruction
1. Plug in the DBSCAR connector line.
2. Connect DBSCAR to the X431 scanner via a USB cable.
3. Connect DBSCAR to X-Prog3 via a three-way extension cable.
4. Insert MCU-V3 board into X-Prog3 if any.
5. Connect the power cable to the MCU board via a three-way cable. Plug the BENCH cable into the MCU board.
6. Connect the BENCH cable & control unit via flash cable.
Completed.
www.obd2shop.co.uk
Post je objavljen 28.11.2022. u 07:17 sati.