Marketing
Ford DPS6/MPS6 Gearbox Clone with Yanhua Mini ACDP
This is a tutorial on how to clone Ford DPS6 & MPS6 gearbox module with Yanhua Mini ACDP step by step. The MPS6 gearbox clone procedure also applies to Volvo, Land Rover, Chrysler, Dodge, etc.
How to Clone Ford DPS6 Gearbox?
Tip: Click "Help" to view the connection diagram before operation.
Accessories Required:
Ford DPS6 gearbox module
20PIN cable
OBP+ICP adapter
ACDP host
Module 26 Ford DPS6 interface board
Connection
1. Install the interface board.
2. Short the jumper cap on the OBP+ICP adapter to the "CAN-R" JOIN side.
3. Connect to ACDP together
Operation
Step1. Backup Original Data
Mini ACDP >> Ford >> Gearbox clone >> DPS6 >> Connect >> OK
Please ensure a stable network connection.
DO NOT pull out the device during working.
Click "Continue".
Check system info,
Continue >> OK >> OK >> OK
Read/write data >> Full backup data >> OK >> Continue
Save chip data.
Reading chip data finished.
Return back to the previous page.
Disconnect >> OK >> Continue
Disconnect finished.
Step2. Write to New Gearbox
Connect the new DPS6 gearbox module & prepare to write the original data.
Connect >> OK >> Continue >> Continue >> OK
Connect system finished.
Read/write data >> Full write data >> OK >> Continue >> Load original data file
Ready to write chip data, please don't cut the power nor pull out the device during the programming!
Click "Continue".
Writing chip data finished.
Return back to the previous page.
Disconnect >> OK >> Continue
Disconnect finished.
Completed!
How to Clone MPS6 Gearbox?
Tip: Click "Help" to view the connection diagram before operation.
Accessories Required:
MPS6 module
OBP+ICP adapter
ACDP host
20PIN cable
Module 14 MPS6 interface board
Connection
1. Install the MPS6 interface board.
2. Short circuit the CAN resistor on the OBD+ICP adapter to the "CAN-R" JOIN side.
3. Connect ACDP, OBP+ICP adapter & MPS6 gearbox.
Operation
Step1. Backup Data
Mini ACDP >> Jaguar/Land Rover >> Gearbox clone >> Freelander >> MPS6 >> Full backup data >> Continue
Remember to save module info, click "Continue".
Save chip data file.
Backup chip data finished.
Step2. Write Data
Connect the new MPS6 gearbox & prepare to write the original data.
Full write data >> Continue >> Continue >> Load chip data file
Ready to write chip data, please don't cut the power nor pull out the device during the programming!
Writing chip data finished.
Completed.
www.obd2shop.co.uk
Post je objavljen 24.08.2022. u 08:56 sati.