Marketing
What's Godiag Full Protocol Obd2 Jumper? How to Use?
Godiag Full Protocol Obd2 Jumper is quite convenient to cooperate with ECU programmers & key tools via OBD in various scenes:
1. Work as EIS/ELV test line for Mercedes with CGDI or VVDI MB;
2. Work with key tools to program immo keys, like VVDI Key Tool Plus;
3. Work as tricore cable for ECU programmers to read data, such as MPPS, KESS V2, MPM, etc.
4. Provide power supply for ECU;
5. Convert vehicle power supply to 12V.
Features
1. Clear identification on each wire.
2. Equipped with a simulative ignition.
3. External 12V power supply connector.
4. Can connect to lock, ECU & BCM module.
5. Helpful for car repair & maintenance.
How to connect Godiag Obd2 Jumper?
1. Check ECU model: it's Cadillac E67.
2. Connect Godiag Obd2 Jumper according to ECU interface definition diagram, confirm all terminals are correctly connected.
3. Connect 120ohm CAN protocol resistor again.
4. Connect ECU dedicated regulated power supply & Godiag GT105.
5. Turn on the analog ignition switch to check whether the ECU can send CAN protocol communication.
6. Connect MPM ECU programmer to computer.
(Godiag obd2 cable supports to use alone, GT105 in the case is for checking protocols communication status. When GT105 indicators are flashing that means communication is normal.)
Application:
Clone Cadillac E67 with PCMtuner MPM + GT105 OK.
Read 2008 Chevrolet Avalanche E38 GM Gen4 ECM with MPM OK.
Program Benz W221 All Key Lost with VVDI MB Tool OK.
Read Audi A6 Simos 6.2/6.3 ECU data & password with VVDI2 OK.
Test ECU Status with Godiag GT101 PIRT Power Probe.
www.obd2shop.co.uk
Post je objavljen 30.05.2022. u 15:57 sati.