Marketing
Tachograph Programmer CD400 Odometer Test - How to
It’s aimed to help use Tachograph Programmer CD400 for odometer test
The CD400 programmer will automatically simulate a speed of 50km/h on 1000m distance and check if the odometer as been incremented by 1000m.
For the K1314/1318 the K reference is set to the last K measured if available, otherwise it is set to 8000.
For the other tachographs the K reference is set to the K factor programmed in the tachograph.
If required, the K reference can be adjusted manually pressing 'F1' (MODIFY).
KTCO1318/FTCO1319/EGK100
Press 'F2' to adjust the position of the start point. Press 'F3' (START) to start the test.
Wait until the progress bar is completed. The test can be aborded pressing 'F3' (STOP).
MTCO/VR2400/DIGITAL
The inital value of the odometer (D1) will be read. Press 'F3' (START) to start the test.
Wait until the progress bar is completed. The test can be aborded pressing 'F3' (STOP).
At the end of the test, the final odometer value will be read (D2). The difference between D2 and D1 will be calculated (D2-D1). If the difference equals 1000m, the test has been successful.
Tachograph CD400 buy:
http://www.chinacardiags.com/wholesale/tacho-programmer-tachograph-programmer-cd400.html
Post je objavljen 14.11.2018. u 03:42 sati.