Marketing
How to read Opel EDC17C59 Insignia 2013 by NEW KTAG FW 7.020?
This blog is going to tell you 2 things:
- Brand-new 2017 KTAG FW 7.020 Ksuite V2.23 is now available!
- Newly tested KTAG Firmware 7.020 read 2013 Opel Insignia EDC17C59 ECU OK!
All you need:
KTAG Cable 14P600KT02
16-way rainbow ribbon cable 144300T105
Two 470 Ohm resistors
Solder wire
KTAG Firmware 7.020 read Opel EDC17C59 pinout& wiring diagram
Solder the two 470 Ohm resistors on the pads as picture:
Solder a wire joining the two pins BOOT and solder a wire to pin CNF1 as picture:
Use the Cable 14P600KT02 to connect KTAG with ECU EDC17C59 as picture:
Solder the rainbow ribbon cable 144300T105 to the pads as picture: (Make sure not to make short circuit between the pads)
So connect KTAG 7.020 with Opel EDC17C59 ECU like this:
After that, open K-Suite V2.23 software.
Choose "OPEL"’ "Insignia"’ the right "BOSCH EDC17C59" and click "OK".
Choose "BOSCH EDC17C59 IROM TC1767 OPEL GPT (P688)".
Click "Read" to read ECU data and wait it complete 100%!
Tips: (SE135) KTAG FW7.020 PCB Board for checking
Post je objavljen 29.08.2017. u 08:18 sati.