Did you accidentally slip your Nintendo off your hand(s), where it fell hard on the floor and you broke a hinge or get a nasty scratch visible on your Nintendo DS case? Before you curse yourself, rest easy that you could replace your Nintendo DS case on your own. But be warned, it is a tricky job. You need special tools and LOTS of patience. If you don't think you have what it takes, it is always better to send it in the nearest trusty store for repair.
If you have the guts to do this, let's begin. When you are calm and ready to hide their Nintendo ds case, place a cloth or towel to the base and bring a dish to implement the screws.
Now turn your DS near to to make certain the fact that back again facet is facing you wonderful up. First, remove the two rubber pads on top. Then, remove the battery situation screw inside the reducing wonderful corner, two other screws inside the left side, as well as the screw inside the ds slot. consider the battery off; remove the screw as well as the include within too. subsequent all screws are secured in your saucer, remove this backside carefully. remove all components by employing the shell, but be cautious if you're removing the shoulder buttons as they have springs that may start out.
Take out the dark and bright wires near to the DS card slot, and consider the dark just one below the slot for another side. Then remove the screws on both side. You can now remove the PCB by employing another half from the bottom element of your Nintendo case.Remove the two screws on best A-B-X-Y buttons, and flip the dark bar above the path pad upside to snap away the flat cable tv and lightly consider it away downwards. remove the energy indicator. founded the flat cable tv inside the slim slot, push it left sensible although pushing the shell wonderful sensible for the flat cable tv at exactly the very same time. Now remove the bottom element by employing the best element of your Nintendo DS case, and founded it aside.
Turn your thought for that best element within of the case. Slip out the angle adjuster inside the left side, roll the flat cable tv set and consider away the ring within another side. Next, appear in the best screen. There are 4 screws concealed beneath pads on every corner near to the best screen, get rid of the two the covering as well as the screws. It's a tad challenging, so consider your time.
When you're done, push this top part with your thumbs on each side of the screen and your index fingers underneath, and slide it upwards. You should be able to open the top shell. Roll the flat wire and push right wise to take it off completely. Congratulations! You can now change each and every bit of your Nintendo ds case. Please assemble them in backward manner accordingly.
Post je objavljen 11.09.2010. u 03:12 sati.