splitters undergo great stresses and pressure

If you can, jack up each tire and spin it to make sure the bearings turn smooth and quiet. Here is what you should look for when looking China Filter funnel Factory at used splitters. If not they would quickly self destruct. When choosing a splitter look for a frame built of thick steel, especially the main I beam. If you can get a used one for a much discounted price this may be the way to go. Hydraulic components use oil as a transfer of energy so there is very little metal on metal and hydraulic components are naturally long lasting.

Because of this and because of how simple these machines are they really don't wear out very fast if they are well built. Sometimes hoses may look bad on the outside but it&s just the outside layer and the hose can last a long time. Check the condition of the hoses. If possible test it first and make sure the beam doesn't flex much if at all when splitting a tough piece. Look for good solid welds and large high grade bolts. The main thing is to get Hydraulic fittings. Check the hydraulic components for leaks.Writing Sooper iclesFind Interesting Contents. Even if parts do wear out most of them are relatively inexpensive. If the pump, cylinder, or control valve is leaking hydraulic fluid it could be an indication that these components will eventually need to be replaced or repaired.

If the high pressure hoses have deep cracks or gouges replace them. This should give you some idea of what to look for when looking for a used splitter. Leaking hydraulic hoses and fittings may need to be replaced but in many cases just tightening them will stop the leak. Hydraulic splitters undergo great stresses and pressure in their operation so they must be built from durable materials and parts. After that the components can be replaced easily even if you are only mildly mechanically capable. The fluid should be relatively clean and not black and should not have water in it.

Although sometimes hydraulic components can leak for a long time and still work fine, but hydraulic fluid is not cheap so it may cost less in the long term to replace the parts. Here are a few things to look for. I have three log splitters that have been in commercial service for over 20 years and they are all still using the original hydraulic components.If you have a good frame to start with it should last a long time. Some engines can be replaced for $300 to $400 but some brands are much more. Make sure it is easy to start and runs smooth.. Since hydraulic log splitters can last for so long, purchasing a used splitter can be a good idea. A hose bursting and shooting hot hydraulic fluid everywhere is not much fun. If not it may need work or need to be replaced. If you have to replace some of the mechanical components you can figure that into the price when negotiating with the seller. The engine is usually the most expensive part of a splitter and also the most likely component to wear out