Adding subwoofer to stock car radio?

We also carry a small selection of highly conductive, pure copper , available by the foot, that will also work well, if you don't want the 9-wire, all-in-solution used above. Seems to me that the amp you're using is not stable to be bridged into 2ohms.

Oath stellt Ihnen auch personalisierte Anzeigen auf den Produkten unserer Partner zur Verfügung. Still use the method described above but the spliced in wire would go directly to the sub amp high level input. That's the bottom side of the triangle in the photo — speaker wires from the amp connect to the speaker wires on the adapter harness.

How to Wire an Amp & Subwoofers Into a Stock Stereo - Genocydal, depending on how powerful your aftermarket amplifier is, allong with tapping off the 3 factory wires, you'll need to run atleast 8awg power and ground wires with an inline fuse. Thanks for the help!

If you want to hype up the audio in your automobile, installing a subwoofer system is the best way to do it. There are different types of systems srock can use to bring your car stock to the next level and holing up your car with can is easy enough if you have the proper tools and know-how. You need to pass the wire through the firewall. Start from the battery and pass on to the amplifier. However, do caan connect the wire to the amplifier or battery yet. Step 2: Removing the Stock Stereo Remove the amp car radio from the dashboard of your car. Make sure that you carefully remove the screws that hold the u; in place ensuring that csn wires are cut. Step 3: Installing the Remote Wire Once you remove the radio stereo, you will see a blue and white wire, which is basically your remote wire. This wire is located at the back of the stereo deck. Get the remote wire in your wiring kit. Once you splice it, solder this wire to the remote wire of your stock stereo. After this is done, run the hook wire through the dashboard and the door jam. Once this is done, you can now run the wires back into the amplifier.


How to install amp on factory radio w/ out opening dash.
Step 3: Installing the Remote Wire Once you remove the stock stereo, you will see a blue and white wire, which is basically your remote wire. The only way you can tell if your amps can be strapped together and how to wire them is by referring to their instruction manual. So really I'm cutting the harness in half and adding a lc7i and an amp. A 9-conductor cable carries four amplified channels from the amp's output to the vehicle's harness, which connects to the speakers via the factory wiring. Their toll-free number would be on your invoice.

[Hook up roku 3|Online chat matchmaking|English dating website switzerland]

Oznake: How, To, Hook, up, a, 4, Channel, Amp, Into, stock, radio, Stereo