BILGE PUMP INSTALLATION INSTRUCTIONS - SUMP PUMP PURCHASE - POND PUMP WATER
Bilge Pump Installation Instructions
- 1. Consult local codes for specific installation requirements and restrictions applicable to your area. It is recommended that system supply pressure be at least 20psi (133kPa). 2. These instructions apply to series 825YD, and 826YD size 2 ? " to 10" (65-250mm) only.
- Instructions and recommendations for proper assembly, adjustment, and installation of listed equipment. SuperVent Instructions are packed with the Chimney Support. DSP Instructions are packed with the Telescopic and Adjustable Lengths.
- a pump to remove bilgewater
- A bilge pump is a water pump used to remove bilge water. Since fuel can be present in the bilge, electric bilge pumps are designed to not cause sparks. Electric bilge pumps are often fitted with float switches which turn on the pump when the bilge fills to a set level.
- A small pump fitted in ships to pump the bilges clear of water
engine guards
ENGINE PROTECTOR
Tank and protective relay for motor handle SUZUKI DL 650 v-river article number: 502.308 00 01 black NOTE:
IMPORTANT NOTE: First left side completely installed, then right side.
Otherwise the engine can lower itself!
Assembling instructions
position number of designation attachment (A) for 1 tank and protective relay for motor handle on the left of above ' 1 tank and protective relay for motor handle right †
4 aluminum distances ? 18 x ? 9 x 13 mm...
4 flange head screws M 8 x 45 attachment (B) † 4 aluminum distances ? 18 x ? 9 x 13 mm in the back... 4 flange head screws M 8 x 45 attachment (C) ? 1 reinforcement handle of the reinforcement handle ‡ 4 hexagonal screws M 8 x 20 ? 4 u-disks ? 8.4 mm ‰ 4 plastic caps M 8 after the assembly all screw connections for tightness control. Please you consider our separate service references!
toprack pic
Luggage bridge (Toprack) SUZUKI DL 650 v-Strom SUZUKI DL 1000 v-Strom
PIC HERE OF TOPCASE
article number: 650.3501 01 01 650,368 01 01
the kit covers the following parts:
1 luggage bridge
4 truss head screws M 6 x 20
4 self-locking nuts/mothers M 6
8 u-disks ? 6.4 mm of
assembling instructions
Seat and original luggage bridge dismantle.
The rubber cover from the original luggage bridge solve; it is void.
Now the Hepco & Becker install luggage bridge in the free drillings, which are congruently present.
Use for this the truss head screws M 6 x 20 together with UScheiben and self-locking nuts/mothers.
Control all screw connections after the assembly for tightness!
Please you consider our attached service information.
Related topics:
solar water pumps south africa
buy hand pump
bosch rexroth gear pump
constant pressure pump controller
hvac heat pumps
12 volt hydraulic pump motor
slurry pumps india
pump it up union city
haldex hydraulic gear pump
purolator fuel pump
|